Lenze PLC Designer Migration PLC Designer (R2-x)-PLC Des Instrukcja Użytkownika Pobierz pdf (Strona 13)

Lenze · PLC Designer | Migration of V2.x projects · 1.2 EN - 02/2013 13

General information

Control configuration

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

4. The wildcard describes a program:

$Program$.bToggle ??PLC_PRG.bToggle

• This type of wildcard replacement cannot be imported into the »PLC Designer« V3.x. (This

wildcard replacement is only used in exceptional cases.)

5. The wildcard is replaced by different types:

$Var$

 Replacement 1 : PLC_PRG.n (INT)

 Replacement 2 : PLC_PRG.st (STRING)

• Remedy: Two different wildcards must be defined in the interface.

6. The visualisation is in a library. The wildcards will be replaced later from any project.

• Remedy 1: The TYPE_NONE data types must be replaced manually.

• Remedy 2: The library must be implemented into a project and the wildcard must be replaced

correctly. If this project is then imported, the data type is determined correctly in the library

as well.

Grouping

• Groups and (not yet) available elements cannot

be imported into the »PLC Designer« V3.

5.3 Control configuration

The control configuration of a »PLC Designer« V2 project cannot be imported into the »PLC Desig-

ner« V3.

As a consequence...

• the device configuration must be created anew .

• the variables in the control configuration must be declared anew.

5.4 Network variables

• In the »PLC Designer« V3.x, GVL objects are created. The variable declarations can be imported.

• The network properties are not

imported.

5.5 Access to the CANopen master or CANopen slave

The access to internal variables of the CANopen master/CANopen slave (e.g. nStatus) via the

global data structures existing in the »PLC Designer«< V2 project is not

possible in the »PLC Desig-

ner« V3.

• The access takes place in the »PLC Designer« V3 via function calls of the CiA405 library (new in

V3).

5.6 L-force Motion

5.6.1 AxisGroup not available anymore

The axis groups used in »PLC Designer« V2 are not available in V3.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 29 30

Brak uwag

Lenze PLC Designer Migration PLC Designer (R2-x)-PLC Des Instrukcja Użytkownika Strona 13