Lenze 11.218 Variable speed pulleys Instrukcja Użytkownika Strona 13

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 26
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 12
Mechanical installation
Mounting
MA 11.1023 DE/EN/FR 3.0
13
H2_montage-anbau-zentralverstellg
1
2
3
1
4
Straight
edge
K11.0260
Fig. 4 Alignment of the pulleys
1 Axial tightening screw 3 Thrust ring
2 Circlip/retaining ring 4 Ring
Center distances of the pulleys
Center distance ”a” (Fig. 5) must be set as given in Tab. 2. Take care that the wide section
V-belt does not protrude over the edge of the pulley face, and also that it does not run onto
the central hub of the movable pulley flange. The limits must be set by the stops/locking
nuts that are provided on the adjusting spindle.
Note!
When replacing the belt, check the limits and reset them, if necessary, because
the belts have a certain amount of tolerance.
K11.0375/1
Fig. 5 Positioning of the wide section V-belt
Przeglądanie stron 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 25 26

Komentarze do niniejszej Instrukcji

Brak uwag