Lenze E84DGFCC Instrukcja Użytkownika Pobierz pdf (Strona 34)

Communication manual 8400 motec CANopen

Commissioning

Settings in the Lenze »Engineer«

34 L EDS84DMOTCAN EN 3.0 - 11/2011

6.4 Settings in the Lenze »Engineer«

The following settings can be made in the »Engineer« under the Settings tab:

 CAN node address (C00350

)

– The node address can only be parameterised if the node address "0" is set via the DIP

switches.

– A change of the node address will only become effective after a CAN reset node.

 CAN node is slave or master (C00352

)

 Deceleration during status change from "Boot-up" to "Operational" (C00356/1

)

 Time to the first transmission of CANx_OUT in the "Operational" state (C00356/4)

Save changed settings with the device command C00002/11 (save all parameter sets).

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 110 111

Brak uwag

Lenze E84DGFCC Instrukcja Użytkownika Strona 34