Lenze E94AYFLF Digital frequency module Instrukcja Użytkownika Pobierz pdf (Strona 13)

EDS94AYFLF EN 3.2 - 10/2010 L 13

Digital frequency extension module | Parameter setting & configuration

Digital frequency input

Parameter setting

2.2.4 Use of machine parameters for scaling

This function extension is available from software version V3.0 onwards!

The input DFIN_AxisData can be used to transfer the machine parameters of the own

motor/drive or of a higher-level drive to the system block LS_DigitalFrequencyInput.

 If valid machine parameters are applied to the input DFIN_AxisData, then the outputs

for the actual position and the actual speed are evaluated on the basis of the

transferred machine parameters (gearbox factors, encoder resolution).

– The position is scaled to the set measuring system/traversing range.

– The encoder mounting position can be parameterised under C13015

/ C14015.

 If the input DFIN_AxisData remains unused, the system block continues to operate as

before. In this case the units are scaled to revolutions.

 Tip!

With this function extension, the system block LS_DigitalFrequencyInput can be

coupled directly to a master value measuring system. The system block then uses

the units of this measuring system for processing.

Short overview of the parameters for this function extension:

Parameter Info Lenze setting

 

Value Unit

C13015 C14015 Encoder mounting position DFIN Clockwise rotation

C13035/1 C14035/1 Position unit DFIN -

C13035/2 C14035/2 Speed unit DFIN -

C13036 C14036 Actual position DFIN - Unit

C13037 C14037 Actual speed DFIN - Unit/t

 Digital frequency extension module in module receptacle MXI1

 Digital frequency extension module in module receptacle MXI2

Greyed out = display parameter

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 53 54

Brak uwag

Lenze E94AYFLF Digital frequency module Instrukcja Użytkownika Strona 13