Lenze ETC Motion Control Instrukcja Użytkownika Pobierz pdf (Strona 85)

100

101

Getting started

Updating the firmware of the ETCHx in the "Standalone" operating mode

Updating the firmware

2.16

2.16.3

EDSTCXN EN 2.0

Firmware file names: ETCHC_A.rsc (ETCHC with 4 MB) or ETCPC.rsc

(ETCPC)

ETCN098

3. Click on Send.

While the file is being loaded into the control system, the following figure

is displayed. On the ETC front plate, the LEDs 1 ... 6 flash circulatingly.

ETCN099

After loading is complete, the following figure is displayed:

ETCN100

The control system waits until the firmware is loaded; on the ETC front

plate, the LEDs 1 ... 6 light up circulatingly.

4. In the HyperTerminal window, enter quit .

The firmware starts. On the ETC front plate, the green watchdog LED

lights up.

1 2 ... 80 81 82 83 84 85 86 87 88 89 90 ... 427 428

Komentarze do niniejszej Instrukcji

ama 11 Jan 2025 | 19:35:39

rasha

Lenze ETC Motion Control Instrukcja Użytkownika Strona 85

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Lenze ETC Motion Control