Lenze CANopen Controller-based Automation Instrukcja Użytkownika Pobierz pdf (Strona 22)

Lenze · Controller-based Automation · CANopen® Communication Manual · DMS 6.3 EN · 04/2014 · TD17 22

5Technical data

5.4 Bus cable length

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

5.4 Bus cable length

5.4.1 Total cable length

The total cable length is also specified by the baud rate.

5.4.2 Segment cable length

Repeaters divide the total cable length into segments. The segment cable length is defined by the

cable cross-section and the number of nodes per segment. Without a repeater, the segment cable

length corresponds to the total cable length.

 Note!

• It is absolutely necessary to comply with the permissible cable lengths.

• Observe the reduction of the total cable length due to the signal delay of the repeater.

Use of repeaters

( 23)

• If the total cable lengths of the nodes are different at the same baud rate, the smaller

value must be used to determine the max. cable length.

Baud rate [kbps] Max. bus length [m]

Servo Drives

9400

Inverter Drives

8400

I/O-System 1000

(EPM-Sxxx)

CANopen bus coupler

10 8000 - 5000

20 4000 - 2500

50 1500 1500 1000

125 600 600 500

250 275 275 250

500 110 110 80

1000 13 13 25

Max. number of

nodes per segment

Cable cross-section

0.25 mm

0.50 mm

0.75 mm

1.00 mm

2 240 m 430 m 650 m 940 m

5 230 m 420 m 640 m 920 m

10 230 m 410 m 620 m 900 m

20 210 m 390 m 580 m 850 m

32 200 m 360 m 550 m 800 m

63 170 m 310 m 470 m 690 m

100 150 m 270 m 410 m 600 m

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 109 110

Komentarze do niniejszej Instrukcji

Brak uwag

Lenze CANopen Controller-based Automation Instrukcja Użytkownika Strona 22

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Ekwipunek Lenze CANopen Controller-based Automation