Lenze EtherCAT Controller-based Automation Instrukcja Użytkownika Pobierz pdf (Strona 196)

13 Parameter reference

196 Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

13 Parameter reference

This chapter complements the parameter list of the online help for the Lenze Controller by the

parameters of the EtherCAT communication interface.

These parameters ...

• are for instance shown in the Lenze »WebConfig« (Engineering tool for web-based

parameterisation);

• are listed in numerically ascending order.

C280/4

C281/2

Parameter | Name:

C280/4 | ECAT bus scan compliance

Data type: UNSIGNED_8

Index: 24295.4 =

0x5EE7.0x04

Brief information on whether the master configuration corresponds to the physical bus structure. The master

configuration of the stack is compared to the actual bus structure.

Selection list (Lenze setting printed in bold) Info

0No match The master configuration does not correspond to the bus

structure.

1 OK The master configuration corresponds to the bus

structure.

 Read access  Write access  CINH  PLC-STOP  No transfer

Parameter | Name:

C281/2 | ECAT master: State

Data type: UNSIGNED_8

Index: 24294.2 =

0x5EE6.0x02

Display of the current master state

Selection list(read only)

0 Unknown

1 Init

2 Pre-operational

3 Bootstrap Mode Bootstrap mode is not supported.

4 Safe-operational

8 Operational

 Read access  Write access  CINH  PLC-STOP  No transfer

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 204 205

Brak uwag

Lenze EtherCAT Controller-based Automation Instrukcja Użytkownika Strona 196