Lenze EtherCAT Controller-based Automation Instrukcja Użytkownika Pobierz pdf (Strona 49)

Lenze · Controller-based Automation · EtherCAT® Communication Manual · DMS 6.4 EN · 04/2014 · TD17 49

7 Commissioning of the system

7.3 Detailed description of the commissioning steps

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

7.3.4.2 i700 parameter management in »EASY Starter«

For parameter management in »EASY Starter«, you must insert the Lenze Controller and the Servo-

Inverter i700 into the device list with the help of the button.

[7-3] Parameter set transfer with »EASY Starter«

With »EASY Starter«, there are two application cases for parameter management:

A. Storing the current Servo-Inverter i700 parameter setting in the Lenze Controller with mains

failure protection:

• Select the Lenze Controller from the device list.

• With the button or the <F6> function key, store the parameter set in the controller so that

it is saved there even in the event of a power failure. (To this end, the controller uploads all

the parameter sets of the lower-level i700 servo inverter.)

• After the system has been switched off and then switched on again. the controller transfers

the parameter sets to the i700 inverter again.

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 204 205

Brak uwag

Lenze EtherCAT Controller-based Automation Instrukcja Użytkownika Strona 49