Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Instrukcja Użytkownika Pobierz pdf (Strona 13)

Lenze · ApplicationTemplate · 1.3 EN - 04/2013 13

Requirements

System requirements

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

3 Requirements

3.1 System requirements

3.2 Establishing communication with the controller

• Connect the Engineering PC with the controller via a network cable. The »PLC Designer«

accesses the controller via Ethernet.

• Make the IP settings with the »PLC Designer«.

 How to check the communication settings:

1. Double-click the desired controller in the Devices view.

2. Make the desired settings on the Communication settings tab.

•Click the Add gateway button to insert a gateway.

Engineering PC Controller

Hardware PC/notebook PLC (Logic) from firmware V3.3

Operating system Windows XP Windows CE

Required Lenze software »PLC Designer« from V3.3

•Contains the

ApplicationTemplate

• Contains the Lenze library

"L_EATP_ApplicationTemplate.co

mpiled-library"

Runtime software

•Logic

• Motion (this requires updating the

project information: "Update

devices")

Further requirements - Depending on the application case:

• CAN or EtherCAT bus system

• CAN or EtherCAT node

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 176 177

Brak uwag

Lenze PLC Designer ApplicationTemplate (PLC Designer R3- Instrukcja Użytkownika Strona 13