Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x) Instrukcja Użytkownika Pobierz pdf (Strona 66)

2.12 MCTRL_MotorControl (node number 131)

9300 Servo PLC

System blocks

2−52

9300 Servo PLC EN 5.0

2.12.7 Speed controller

The speed controller is designed as an ideal PID controller.

Parameter setting

By selecting a motor under C0086 the parameters are preset, making most adaptations to the

application unnecessary.

 The proportional gain V

can be set under C0070:

– Enter approx. 50 % of the speed setpoint (100 % = 16384 = N

max

– Increase C0070 until the drive becomes unstable (pay attention to motor noise)

– Reduce C0070 until the drive runs stable again.

– Reduce C0070 to approx. half the value.

Code LCD

Possible settings

Info

Lenze Selection

C0070 Vp speed CTRL

 Proportional gain of speed controller

)

 Dependent on C0086

 If C0086 is changed, the value is

reset to the assigned Lenze

setting.

0.0 {0.5} 255.0

 The reset time T

can be set under C0071:

– Reduce C0071 until the drive becomes unstable (pay attention to motor noise).

– Increase C0071, until the drive runs stable again.

– Increase C0071 to approx. twice the value.

Code LCD

Possible settings

Info

Lenze Selection

C0071 Tn speed CTRL

 Reset time of speed controller (T

)

 Dependent on C0086

 If C0086 is changed, the value is

reset to the assigned Lenze

setting.

1.0 {0.5 ms} 600.0

>512 ms = switched off

 The derivative gain T

can be set under C0072:

– Increase C0072 during operation until the drive reaches an optimum control performance.

Code LCD

Possible settings

Info

Lenze Selection

C0072 Td speed CTRL

0.0 Derivative gain of speed controller

)

0.0 {0.1 ms} 32.0

 Via MCTRL_nNAdapt_a the proportional gain V

can be changed using the PLC program:

= MCTRL_nNAdapt_a [%] C0070

Default: MCTRL_nNAdapt_a= 100 % V

= 100 % C0070 = C0070

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 166 167

Komentarze do niniejszej Instrukcji

Brak uwag

Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x) Instrukcja Użytkownika Strona 66

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Sprzęt komputerowy Lenze Drive PLC Developer Studio 9300 Servo PLC (V8.x)