Lenze PLC Designer PLC Designer (R2-x) Instrukcja Użytkownika Pobierz pdf (Strona 173)

100

101

L-force | PLC Designer

The Individual Components

 DMS 3.2 EN 02/2011 TD29 171

6.3.45 'Project' 'User group passwords'

With this command you open the dialog box for password assignment for user

groups. This command can only be executed by members of group 0. When the

command has been given, then the following dialog box appears:

Dialog box for password assignment

In the left combobox User group you can select the group. Enter the desired password

for the group in the field Password. For each typed character an asterisk (*) appears in

the field. You must repeat the same password in the field Confirm password. Close the

dialog box after each password entry with OK. If you get the message:

"The password does not agree with the confirmation",

then you made a typing error during one of the two entries. In this case repeat both

entries until the dialog box closes without a message.

Then, if necessary, assign a password for the next group by calling the command

again.

 Note!

If passwords are not assigned to all user groups, a project can be opened by way of a

group to which no password was assigned!

Use the command 'Object' 'Access rights' to assign the rights for single objects or all of

them.

Concerning the protection of a project regard also the following:

• Passwords for access and write protection

• Encryption of a project at project saving

1 2 ... 168 169 170 171 172 173 174 175 176 177 178 ... 843 844

Komentarze do niniejszej Instrukcji

Brak uwag

Lenze PLC Designer PLC Designer (R2-x) Instrukcja Użytkownika Strona 173

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Lenze PLC Designer PLC Designer (R2-x)