Lenze PLC Designer PLC Designer (R2-x) Instrukcja Użytkownika Pobierz pdf (Strona 420)

100

101

L-force | PLC Designer

The Resources

418 DMS 3.2 EN 02/2011 TD29 

The possible stati:

Idle has not been started since last update; especially used for event tasks

Running has been started at least once since last update

Stop stopped

Stop on BP stopped, because breakpoint in task is reached

Stop on Error Error, e.g. division by zero, page fault etc.

Stop Watchdog cycle time has been exceeded

The task entry will be displayed red coloured in case of status 'Stop on Error' or 'Stop

Watchdog' .

Display of the time flow of the tasks

If the entry 'Taskconfiguration' is selected in the configuration tree, the utilization of

the tasks will be displayed in bar charts in the right part of the window:

Display of the Task Execution in Online Mode

For each task a bar chart is displayed. The length of the bar represents the length of a

cycle period. Below the bar as well as by appropriate marks on the bar the following

measurement values are illustrated:

Min: minimum measured runtime in μs

Akt: last measured runtime in μs

Max: maximum measured runtime in μs

Cycle: total length of a cycle in μs

Jitter: maximum measured jitter (time between when the task was started and when the

operating system indicates that it is running) in μs

1 2 ... 415 416 417 418 419 420 421 422 423 424 425 ... 843 844

Komentarze do niniejszej Instrukcji

Brak uwag

Lenze PLC Designer PLC Designer (R2-x) Instrukcja Użytkownika Strona 420

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Lenze PLC Designer PLC Designer (R2-x)