Lenze PLC Designer PLC Designer (R2-x) Instrukcja Użytkownika Pobierz pdf (Strona 322)

100

101

L-force | PLC Designer

Editors in PLC Designer

320 DMS 3.2 EN 02/2011 TD29 

If the maximum time is exceeded, SFC flags are set which the user can query.

The example shows a step whose execution should last at least two, and at the most,

ten seconds. In Online mode, there is, in addition to these two times, a display of how

long the step has already been active.

'Extras' 'Time Overview'

With this command you can open a window in which you can edit the time settings of

your SFC steps:

Time Boundaries Overview for a SFC POU

In the time boundaries overview, all steps of your SFC POU are displayed. If you have

entered a time boundary for a step, then the time boundary is displayed to the right of

the step (first, the lower limit, then the upper limit). You can also edit the time

boundaries. To do so, click on the desired step in the overview. The name of the step is

then shown below in the window. Go to the Minimum Time or Maximum Time field,

and enter the desired time boundary there. If you close the window with OK, then all

of the changes will be stored.

1 2 ... 317 318 319 320 321 322 323 324 325 326 327 ... 843 844

Komentarze do niniejszej Instrukcji

Brak uwag

Lenze PLC Designer PLC Designer (R2-x) Instrukcja Użytkownika Strona 322

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Lenze PLC Designer PLC Designer (R2-x)