Lenze PLC Designer PLC Designer (R2-x) Instrukcja Użytkownika Pobierz pdf (Strona 363)

100

101

L-force | PLC Designer

The Resources

 DMS 3.2 EN 02/2011 TD29 361

DP parameters of the DP master

This dialog shows the following parameters extracted from the device file of the DP

master (The dialog might have a different title, which is defined in the configuration

file):

DP parameters dialog for DP master

Info Manufacturer, GSD Revision, ID (identification number), HW Release and SW

Release (hard- and software version), GSD-Filename

Addresses Station address: The allowable range extends from 0 to 126. Each device newly

inserted on a bus line is automatically provided the next higher address. (note:

Address 126 is the default DP slave address). Manual entry is possible; addresses are

tested for duplication.

Highest station address: The highest station address (HSA) assigned on the bus is

displayed. Here, a lower address can also be entered in order to narrow the GAP

range (that is, the address range within which the search for newly-active devices is

carried out).

Mode Auto Clear Mode: If this option is activated, the outputs of the slaves will be

switched to a save state in error case and the master will change from state

"operate" to "clear".

Automatic Startup: If this option is not activated, the master must be started

manually. However it depends on the driver, whether the setting is evaluated.

The GSD-file pertaining to a device can be opened and examined using the GSD-file

button.

1 2 ... 358 359 360 361 362 363 364 365 366 367 368 ... 843 844

Komentarze do niniejszej Instrukcji

Brak uwag

Lenze PLC Designer PLC Designer (R2-x) Instrukcja Użytkownika Strona 363

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Oprogramowanie Lenze PLC Designer PLC Designer (R2-x)