Lenze E94AxHE Servo Drives 9400 HighLine (Firmware 01-37 Instrukcja Użytkownika Strona 71

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 679
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 70
L Firmware 1.37 - 09/2006 71
9400 HighLine | Parameter setting & configuration
Motor interface
Initial commissioning | Set rotor displacement angle
5.1.6 Set rotor displacement angle
For the control of permanent-magnet synchronous machines, the rotor angle – the angle
between the motor phase U and the field axis of the rotor – must be known.
r For Lenze motors the rotor displacement angle for different feedback systems is
already set correctly in C00058/1...3
.
r The device command "Set rotor displacement angle" serves to specify the rotor
displacement angle for the current motor encoder activated in C00495
for an external
motor (see following instructions).
M How to set the rotor displacement angle for an external motor:
1. If the controller is enabled, inhibit the controller, e.g. with the device command
"Inhibit controller" (C00002
= "41").
2. Execute device command "Set rotor displacement angle" with C00002
= "51".
The procedure starts with controller enable, if
a synchronous machine is selected,
no other identification is active,
no error (TRIP) has occurred, and
no test mode is activated.
If one of the above conditions is not met, the procedure is cancelled and the
corresponding controller command status is indicated under C00003
.
Note:
By means of controller inhibit the started procedure can be aborted any time
without making a change in C00058
.
For detailed information about the procedure, please see the following section
"Sequence".
O Tip!
For controller enable all
sources for controller inhibit must be reset. In C00158 the
sources for controller inhibit are displayed in a bit-coded manner.
The status of the controller command activated under C00002
is indicated under
C00003
.
Note!
Not required if a Lenze motor is operated on the controller!
Note!
During the procedure of setting the rotor displacement angle, the machine must
not be braked or blocked.
Przeglądanie stron 70
1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 678 679

Komentarze do niniejszej Instrukcji

Brak uwag